Project

General

Profile

Serial Cable » History » Version 11

tsaitgaist, 02/19/2016 10:48 PM
ftdi better then pl2303

1 1 laforge
2 5 vogelchr
The Calypso phones typically all have a serial port @ 3.3V levels on the 2.5mm earphone jack.
3 1 laforge
4 3 laforge
Those cables are sometimes called ''T191 unlock cable''.
5 1 laforge
6 3 laforge
You can either buy ready-made cables, e.g. at:
7 7 tsaitgaist
 * USB variant
8
  * [https://www.akku-king.net/_py_Handyzubehoer-Datenkabel-USB-Motorola-USB-Datenkabel-fuer-Motorola-T191-C113-C113a-C114-C115-C115i-C116-C117-C118-C119-C121-C122-C123-C136-C139-C140-C155-C156/a-20104991/ akku-king.net]
9
  * [http://www.gsmliberty.net/shop/motorola-t191-dataunlock-cable-p-1252.html gsmliberty.net]
10 9 laforge
  * [http://www.fonefunshop.co.uk/datacables/motorola.htm fonefunshop.co.uk]
11 7 tsaitgaist
 * RS232 variant, you still need a separate standard USB/RS232 cable
12
  * [http://www.handy-style.de/index/cat190/2130 handy-style.de]
13
  * [http://www.cellcorner.com/xshp/unlock-phone-codes/motorola-t190-t191-t193-unlock-data-cable.html cellcorner.com]
14 10 laforge
 * USB/RS232 cable 
15
  * [http://www.tronisoft.com/cat_usbtoserial.php tronisoft.com] (FTDI and Prolific cables)
16 3 laforge
17
Or you can build it yourself (detailed instructions can be found on the net, search for "t191 unlock cable" or the like).
18
19 4 laforge
 * TxD is at the tip of the plug (PC to Device)
20
 * RxD is at the middle contact (Device to PC)
21 1 laforge
 * GND is the outer contact
22 5 vogelchr
23
== Hints and Warnings ==
24
25
 * If you don't use a 3.3V (low voltage TTL, LVCMOS) serial port you can fry your phone! (internally, it connects to the IO-pins of the baseband processor which run at 2.8V). '''Don't connect directly to your PCs serial port (running at +/- 12V!).'''
26
 * If your development system is virtualized (runs inside VMware, Virtualbox, Parallels...) the connections can be unreliable (the loader protocol is timing critical).
27 11 tsaitgaist
 * Your safest bet is a USB cable with a FTDI chip (FTx232) configured for operation at 3.3V connected to a machine running Linux natively. Prolific chips (PL2303) also work, but are far less reliable.
28 8 vogelchr
 * If you want to communicate with the Calypso at baudrates higher than 115200 bps, you'll have to resort to non-standard baudrates. These are also supported best using a FTDI based USB adapter cable.
Add picture from clipboard (Maximum size: 48.8 MB)