Sfp-experimenter » History » Version 1
laforge, 10/07/2018 06:51 AM
| 1 | 1 | laforge | h1. sfp-experimenter |
|---|---|---|---|
| 2 | |||
| 3 | This is the twin brother of the [[sfp-breakout]] board. It contains LVDS receiver/transmitter circuits, so you can use single-ended signals on the electrical side. |
||
| 4 | |||
| 5 | h2. Schematics / Design files |
||
| 6 | |||
| 7 | The schematics / design files are kept in git at https://git.osmocom.org/osmo-small-hardware/tree/sfp-breakout |
||
| 8 | |||
| 9 | h2. Photos |
||
| 10 | |||
| 11 | !sfp-experimenter.jpg! |
||
| 12 | |||
| 13 | h2. Availability |
||
| 14 | |||
| 15 | h2. Errata |
||
| 16 | |||
| 17 | h3. sfp-experimenter v1 |
||
| 18 | |||
| 19 | h4. R6 pull-down re-work |
||
| 20 | |||
| 21 | there was a need to place a bias resistor from RD_N to ground (pin4 on ic2) or the whole board would not work. ic2 has internal 100ohm prom pin3 to pin4 and pullups of ~300k to vcc. 100k pulldown on one leg pushes it into the proper operating range. due to the 100ohm its not neccessary to have more than one pulldown. |
||
| 22 | |||
| 23 | !sfp-experimenter-r6-rework.jpg! |
