Bug #3436
closedqmod: 1: WWAN LED activity not monitored
100%
Description
When the modem is reset (i.e. using the '1' or '2' commands over serial) the WWAN LED (yellow) of the corresponding modem on the qmod board should switch off.
This should be monitored by the SAM3S and any change should be displayed over serial:
"-I- 0: WWAN LED 0" when LED for modem 1 (ST12 port 0) switched off
"-I- 0: WWAN LED 1" when LED for modem 1 (ST12 port 0) switched on
This does not work for modem 2 though (ST12 port 1)
Updated by tsaitgaist over 5 years ago
- Assignee changed from tsaitgaist to mschramm
- % Done changed from 0 to 10
The LED status for WWAN1 is monitored my QMOD board (using ST12 and modem 1 and 2):I 0: WWAN LED 1I 1: WWAN LED 1
2Resetting Modem 2 (of this SAM3)I 1: Asserting modem reset I 1: De-asserting modem resetI 1: CLK deactivatedI 1: VCC deactivatedI 1: WWAN LED 0
I didn't change the code.
Lets check together tomorrow and compare boards.
Updated by mschramm over 5 years ago
- Status changed from New to Resolved
- % Done changed from 10 to 100
Thanks - with current master this error has not been seen again.