https://osmocom.org/https://osmocom.org/favicon.ico?16647414092020-12-19T14:58:24ZOpen Source Mobile CommunicationsE1/T1 Hardware Interface (including icE1usb) - Bug #4918: icE1usb bootloader suddenly 'gone" ?https://osmocom.org/issues/4918?journal_id=206292020-12-19T14:58:24Zlaforge
<ul></ul><p>I've disconnected E1, GPS and also the serial console to see if it might be any external influence, no change.</p> E1/T1 Hardware Interface (including icE1usb) - Bug #4918: icE1usb bootloader suddenly 'gone" ?https://osmocom.org/issues/4918?journal_id=206302020-12-19T15:35:00Zlaforge
<ul><li><strong>Priority</strong> changed from <i>Normal</i> to <i>Low</i></li></ul><p>A few minutes later, it suddenly all works again. not sure what is going on here :(</p> E1/T1 Hardware Interface (including icE1usb) - Bug #4918: icE1usb bootloader suddenly 'gone" ?https://osmocom.org/issues/4918?journal_id=206312020-12-19T15:53:15Ztnt
<ul></ul><p>If this happens gain, some things to look at :</p>
<p>- State of the RGB LED<br />- State of the 'DONE' LED (you can see it through the GPIO connector gap, if there is a blue light inside)</p>
<p>Something to keep in mind as well is that the bootloader loaded on that particular unit is probably not the same version as was loaded on the production units.</p>
<p>If you look at the `no2bootloader` repo, it was created a few days before I flashed all the production units, that's because I did a lot of cleanup/improvement work on it right before flashing all of those. And since the pre-prod unit is from like a month before, it would have an older bootloader and stub code.</p> E1/T1 Hardware Interface (including icE1usb) - Bug #4918: icE1usb bootloader suddenly 'gone" ?https://osmocom.org/issues/4918?journal_id=206572020-12-27T12:12:38Zlaforge
<ul><li><strong>Status</strong> changed from <i>New</i> to <i>Rejected</i></li></ul>