E1-tap » History » Revision 4
Revision 3 (laforge, 05/09/2017 05:12 AM) → Revision 4/6 (laforge, 05/09/2017 05:15 AM)
h1. E1/T1 Tap
The Osmocom E1/T1 tap adapter allows you to tap into the communication of an E1/T1 line.
This is useful for tracing/analyzing communications on any type of E1 based interface, such as A-bis, A and core network interfaces in GSM networks, as well as classic ISDN networks.
Two RJ-45 ports are used for passing through your existing E1 line. Using a switch (SW1), the pass-through can be configured in straight or cross-over mode.
Two additional RJ-45 sockets are provided for tapping into either of the two pairs (Rx/Tx) of the E1 line.
An additional switch (SW2) can be used to select between high and low impedance tapping.
All ports are configured in Digium-compatible pin-out, i,e, pairs 1+2 / 4+5
h2. PCB Photograph
!e1-tap.jpg!
h2. Schematics
!e1-tap-sch.png!