E1-tap » History » Revision 5
« Previous |
Revision 5/6
(diff)
| Next »
laforge, 01/06/2020 04:15 PM
- Table of contents
- E1/T1 Tap
E1/T1 Tap¶
The Osmocom E1/T1 tap adapter allows you to tap into the communication of an E1/T1 line.
This is useful for tracing/analyzing communications on any type of E1 based interface, such as A-bis, A and core network interfaces in GSM networks, as well as classic ISDN networks.
Two RJ-45 ports are used for passing through your existing E1 line. Using a switch (SW1), the pass-through can be configured in straight or cross-over mode.
Two additional RJ-45 sockets are provided for tapping into either of the two pairs (Rx/Tx) of the E1 line.
An additional switch (SW2) can be used to select between high and low impedance tapping.
All ports are configured in Digium-compatible pin-out, i,e, pairs 1+2 / 4+5
PCB Photograph¶
Schematics¶
Availability¶
The E1/T1 tap adapter is available for purchase from http://shop.sysmocom.de/products/e1-t1-tap-adapter
Updated by laforge over 4 years ago · 5 revisions