Project

General

Profile

RJ45 jumper box » History » Revision 3

Revision 2 (laforge, 07/25/2022 07:04 AM) → Revision 3/5 (laforge, 02/14/2023 05:57 PM)

h1. RJ45 jumper box 

 This is a small circuit board that allows you to prototype arbitrary RJ45 cables / pin-outs.    Once the pin-out is confirmed, you can go ahead and crimp a cable with matching pin-out, having verified that it is correct. 

 @laforge finds this very useful, particularly in the context of the many differen RS232 on RJ45 pin-outs in use by various equipment out there. 

 h2. Hardware v1 

 This is a single-layer PCB design. In order to make the PCB routing easy, the RJ45 connectors are on opposite sides of the PCB. 

 !{width:50%}rj45_jumper_box-top.jpg! 

 !{width:50%}rj45_jumper_box-bot.jpg! 

 !{width:50%}rj45_jumper_box-with_cables.jpg! 

 h2. Hardware v2 

 In the hardware version _v2_, the PCB design was switched to a two-layer design, and both RJ45 connectors are now located on the top side of the PCB.    This significantly increases the usability. 

 !{width:50%}rj45-pcba.jpg! 

 h2. Design files 

 The PCB design files are available at https://gitea.osmocom.org/electronics/osmo-small-hardware/src/branch/master/rj45-jumper-box
Add picture from clipboard (Maximum size: 48.8 MB)