Project

General

Profile

HFC-E1 » History » Version 2

nibbler, 02/19/2016 10:47 PM
s/ChipCologne/CologneChip/

1 1 laforge
2 2 nibbler
The HFC-E1 is an E1 controller chipset for PCI bus, produced by CologneChip.
3 1 laforge
4 2 nibbler
CologneChip offers a HFC-E1 Evaluation Board, which is used by our project.
5 1 laforge
Other HFC-E1 cards should theoretically work, too - although this has not 
6
been tested.  The card has to support 120Ohms NT mode.
7
8
== Hardware configuration ==
9
10
We set the Jumper and termination configuration as follows:
11
 * 120 Ohms Termination 
12
  * 1: off
13
  * 2: on
14
 * TE Mode Config A (Pin1/2: Rx, Pin 4/5: Tx)
15
  * All JP6 and JP1 jumpers between pins 1 and 2 (left)
Add picture from clipboard (Maximum size: 48.8 MB)