Bsc nat VTY » History » Revision 9
« Previous |
Revision 9/16
(diff)
| Next »
Anonymous, 02/19/2016 10:48 PM
update VTY config file
This page is a reference fo all VTY commands that you can use interactively on the bsc_nat VTY telnet interface.
In addition, the same commands are used for the configuration file.
configuration reference=== nat level ===
Configure the nat. Global settings
==== msc ip A.B.C.D ==== * Set the MSC IP address used to connect to the MSC.
==== msc port <1-65500> ==== * Set the MSC Port used to connect to the MSC.
==== timeout auth NR ==== * Time in seconds to wait for the authentication reponse of a BSC.
==== timeout ping NR ==== * Time in seconds to wait between two PING messages
==== timeout pong NR ==== * Time in seconds to wait for a reply of a PING before closing the connection
==== token STR ====
* Authentication token used to authenticate the BSC. Currently this is transfered
in clear text.
==== ip-dscp TOS ==== * Set the IP Type of Service (ToS) for the incoming BSC connections.
==== access-list-name ==== * The name of the access-list to use on the NAT. Only the deny rules will be evaluated.
==== bsc BSC_NR ==== * Configure the BSC with the number
===== location_area_code <0-65535> ===== * Set the location area code that this BSC is handling
===== token TOKEN ===== * A token for the BSC. The real bsc needs to send this token to use the lac and other filters. This is no real authentication or security scheme.
===== paging forbidden (0|1) ===== * Decide if paging messages should be forwarded to the BSC.
===== description STR. ===== * A description for the BSC.
===== access-list-name STR ===== * Use the access-list for the BSC. First the deny rule will be evaluated, then the allow rule and then the deny rule of the NAT.
Updated by about 8 years ago · 9 revisions