E1-to-RJ45 » History » Revision 2
Revision 1 (Anonymous, 02/19/2016 10:47 PM) → Revision 2/14 (Anonymous, 02/19/2016 10:47 PM)
== Howto build your E1<>RJ45 cable == We used a Cat-7 Ethernet cable to build our E1<>RJ45 cable to connect the BTS with the BSC. Things you need: * one Cat-7 Ethernet cable * two twinax plugs (BR2) * some heat shrink tube * soldering-iron * multimeter (optional) * a sharp knife :) === Step-by-step guide === '''One:''' Take your cable and cut off one of the RJ45 connectors. Now use a ruler and make a slice so you can strip around 15 cm from you cable. [[Image(IMG_0960-1.JPG, 15%)]] [[Image(IMG_0960-2.JPG, 15%)]] # FIXME images '''Two:''' Split the wires from your cable. We need pin 1 and 2 for '''RX''' (green white/green) and pin 4 and 5 for '''TX''' (blue white/blue), you can use a multimeter if you are not sure that you got the correct wires. Cut off the other wires we do not need them (yet). [[Image(IMG_0960-4.JPG, 15%)]] [[Image(IMG_0960-5.JPG, 15%)]] [[Image(IMG_0960-7.JPG, 15%)]] # FIXME images '''Three:''' Sort your twinax plugs to make sure you build them in the right order. ;)[[BR]] We used heat shrink tube to stabilize our cable around the plugs. [[Image(IMG_0960-9.JPG, 15%)]] [[Image(IMG_0960-11.JPG, 15%)]] [[Image(IMG_0960-7.JPG, 15%)]] '''Four:''' Now you can put everything on the first part of the cable and assemble it. Use a soldering-iron to fixate the each of the two pins of the plug with your wires. [[Image(IMG_0960-9.JPG, 15%)]] [[Image(IMG_0960-11.JPG, 15%)]] [[Image(IMG_0960-12.JPG, 15%)]] [[Image(IMG_0960-17.JPG, 15%)]] # FIXME images '''Five:''' Repeat step '''three''' and '''five''' to build the second plug. [[Image(IMG_0960-19.JPG, 15%)]] # FIXME images '''Done.'''