Project

General

Profile

HFC-E1 » History » Version 5

Anonymous, 02/19/2016 10:47 PM

1 1 laforge
2 2 laforge
The HFC-E1 is an E1 controller chipset for PCI bus, produced by CologneChip.
3 1 laforge
4 3 laforge
There are a number of cards using this chipset, among others
5 5 laforge
 * HFC-E1 Datasheet ([http://www.colognechip.com/hfc-e1.pdf])
6
 * The HFC-E1 Evaluation Board of ChipCologne ([http://www.colognechip.com])
7 3 laforge
 * Beronet BN1E1 Card (http://www.beronet.com/downloads/whitepapers/BNXE1.pdf)
8
 * Junghanns.NET SingleE1 card (http://www.junghanns.net/en/singleE1_produkt.html)
9
10
== Evaluation Board ==
11
12 1 laforge
CologneChip offers a HFC-E1 Evaluation Board, which is used by our project.
13
Other HFC-E1 cards should theoretically work, too - although this has not 
14
been tested.  The card has to support 120Ohms NT mode.
15 5 laforge
16 1 laforge
17 3 laforge
=== Hardware configuration ===
18 1 laforge
19
We set the Jumper and termination configuration as follows:
20
 * 120 Ohms Termination 
21
  * 1: off
22
  * 2: on
23 4 laforge
 * NT Mode Config A (Pin1/2: Rx, Pin 4/5: Tx)
24 1 laforge
  * All JP6 and JP1 jumpers between pins 1 and 2 (left)
Add picture from clipboard (Maximum size: 48.8 MB)