HFC-E1 » History » Version 6
Anonymous, 02/19/2016 10:48 PM
| 1 | 1 | laforge | |
|---|---|---|---|
| 2 | 6 | laforge | The HFC-E1 is an E1 controller chipset for PCI bus, produced by [[CologneChip]]. |
| 3 | 1 | laforge | |
| 4 | 5 | laforge | There are a number of cards using this chipset, among others |
| 5 | 6 | laforge | * HFC-E1 Datasheet ("* The HFC-E1 Evaluation Board of [[ChipCologne]] ([http://www.colognechip.com":http://www.colognechip.com/hfc-e1.pdf])) |
| 6 | * Beronet BN1E1 Card (http://www.beronet.com/downloads/whitepapers/BNXE1.pdf) |
||
| 7 | * Junghanns.NET SingleE1 card (http://www.junghanns.net/en/singleE1_produkt.html) |
||
| 8 | 3 | laforge | |
| 9 | |||
| 10 | 6 | laforge | h2. Evaluation Board |
| 11 | |||
| 12 | |||
| 13 | [[CologneChip]] offers a HFC-E1 Evaluation Board, which is used by our project. |
||
| 14 | 1 | laforge | Other HFC-E1 cards should theoretically work, too - although this has not |
| 15 | been tested. The card has to support 120Ohms NT mode. |
||
| 16 | 5 | laforge | |
| 17 | 1 | laforge | |
| 18 | 3 | laforge | |
| 19 | 6 | laforge | h3. Hardware configuration |
| 20 | |||
| 21 | |||
| 22 | 1 | laforge | We set the Jumper and termination configuration as follows: |
| 23 | 6 | laforge | * 120 Ohms Termination |
| 24 | ** 1: off |
||
| 25 | ** 2: on |
||
| 26 | * NT Mode Config A (Pin1/2: Rx, Pin 4/5: Tx) |
||
| 27 | ** All JP6 and JP1 jumpers between pins 1 and 2 (left) |
