Project

General

Profile

WandelGoltermannMA10 » History » Version 3

Anonymous, 02/19/2016 10:48 PM

1 1 laforge
2 3 laforge
h2. MA10 Hardware
3
4
5 1 laforge
The MA10 is a full-length ISA card for PCs.
6
7
It contains multiple E1 transceivers and has the following external connections
8 3 laforge
* Handset (RJ-11 socket)
9
* RX0 (120 Ohms and 75 Ohms)
10
* RX1 (120 Ohms and 75 Ohms)
11
* TX1 (120 Ohms and 75 Ohms)
12 1 laforge
13
14 3 laforge
h3. Cabling
15
16
17 1 laforge
As we use the BS11 in 120 Ohms symmetric configuration, we also use the 120 Ohms symmetric ports of the MA10.
18
19
The 120 Ohms symmetric ports of the MA10 are all LEMO type FGG.0B.302.CLAD42Z
20
21
22
23 3 laforge
h2. MA10 Software
24
25
26 1 laforge
There are a number of different software packages available for the MA10
27
28
29 3 laforge
h3. MA10 Control
30 1 laforge
31
32 3 laforge
33
h3. BERT
34
35
36
37
h3. Abis Monitor
38
39
40 1 laforge
The Abis Monitor allows you to monitor an Abis link.  You connect the two RX ports to the E1 link and can thus sniff
41
the bidirectional communication between BSC and BTS.
42
43
There are commercial extensions (today they would probably be called plug-ins) that extend the protocol parser
44
with vendor-specific commands, such as the Siemens O&M layer.
45
46
47 3 laforge
h3. Abis Simulator
48
49
50 1 laforge
This is a complete simulator for the BSC side of the Abis link.  Using the Abis simulator and a BTS, you can
51
emulate a GSM network.
52
53
In this mode, the MA10 assumes an active role and thus you need to connect RX0 and TX0 with the BTS.
54
55 3 laforge
56
h3. Restrictions
57
58 2 laforge
59
Audio output/input with headset is not supported by any of the "AbisSim" releases.
60
Only echo loop is supported on traffic channels.
61
This means that using a mobile phone connected to BTS controlled by the MA10
62
can only loop back the audio input form this mobile.  
Add picture from clipboard (Maximum size: 48.8 MB)