Actions
BinTec BIANCA/BRICK-XMP¶
- Table of contents
- BinTec BIANCA/BRICK-XMP
The BIANCA/BRICK-XMP is a ISDN PRI Corporate Access Router (RAS server) made by BinTec that
- terminates one 1E line (30 B-channels)
- provides ISDN dial-up on those channels
- provides DSP based modems in case analog modem calls should be handled.
- supports remote CAPI (CAPI over TCP)
Power Consumption | ~30W |
RS232 Connector | DB9 |
E1 Connector | RJ45 |
ETH Connector | RJ45 |
Hardware¶
External pictures¶
Open Case¶
Power Supply¶
200W FORTRON/SOURCE FSP SPI-200G AT PC power supply
Connector Board¶
Main Board¶
We can see here- Motorola MC68EC020 (Microprocessor) MC68EC020.pdf
- 2x Samsung KM68257C (SRAM) KM68257C.pdf
- Digital 21143-PC (10/100-Mb/s Ethernet LAN Controller) 21143.pdf
- Quality Semiconductor QS611 (10/100BaseTX Symbol Transceiver) QS611.pdf
- Xilinx XC5204 (FPGA) XC5200.pdf
- 2x Xilinx XC9572 (CPLD) XC9572.pdf
- 2x Fujitsu MB84256C (SRAM) MB84256C.pdf
- Motorola ACT574 XAB9802
- Motorola ACT244 XAD9750
- Motorola ACT08 XAA735
- Siemens PEB 20320 H V3.2 (Multichannel Network Interface Controller for HDLC) PEB20320.pdf
- Siemens PEB 2236 N IPAT V2.1 (ISDN Primary Access Transceiver) PEB2236.pdf
- Siemens PEB 2035 N ACFA V4.1 (Advanced CMOS Frame Aligner) PEB2035.pdf
- Epson RTC 72423 (Real Time Clock) RTC72423.pdf
- CR2032 3V battery
- 4x Samsung (DRAM) KM416C1200CJ.pdf
- Sharp LH28F016SCHT-L95 (Flash Memory) LH28F016SCHT.pdf
- 2x Xilinx XC3130A (FPGA) XC3000.pdf
Modem Board¶
top side
- Motorola MC68EC020 (Microprocessor) MC68EC020.pdf
- Xilinx XC5204 (FPGA) XC5200.pdf
- 8x Rockwell L2600-17 (Modem Controller)
- 8x Rockwell RC56DDP (Modem Digital Data Pump) RC56DDP.pdf
bottom side
- 16x G-Link GLT710008 (CMOS SRAM 1M-bit (128K x 8bit)) GLT710008.pdf
- 4x G-Link GLT725608 (CMOS SRAM (32K x 8 Bit) GLT725608.pdf
- 4x Fairchild 74ACTQ16245 (16-Bit Transceiver with 3-STATE Outputs) 74ACTQ16245.pdf
Serial Console¶
Power up¶
### BIANCA/BRICK-XMP - Start-up ### Writing DRAM test pattern: ................................ done Checking DRAM test pattern: ................................ done Initializing FPGAs : ... done Starting RTC test : ... done Starting FLASH Test : ... [0x5e48] done ### 100Base-T Part ### Starting chip test (MAC) : ... done Initializing MAC (Config) : ... done Initializing MAC (CSRs) : ... done Starting local DMA test : ............................... done Starting interrupt test : ... done ### S2M Part ### ### BIANCA/BRICK-XMP (Hardware-Rev. 1.2, Firmware-Rev. 1.2) ok ### Press <sp> for boot monitor or any other key to boot system
Bootmonitor¶
BIANCA/BRICK-XMP Bootmonitor (V. 4.9 Rev. 1 from Oct 13 1998) Copyright (c) 1996 by BinTec Communications GmbH (1) Boot System (2) Software Update via TFTP (3) Software Update via XMODEM (4) Delete Configuration (5) Default Bootmonitor Parameters
Firmware booting¶
Booting Image from Flash ROM Checking image ... OK Writing image to RAM (Release 4.9.3) .................................................OK (2259008 bytes) Booting BOSS... BOSS kernel v2.0 (BIANCA/BRICK-XMP) Copyright (c) 1996 by BinTec Communications GmbH Version V.4.9 Rev. 3 from 98/12/10 00:00:00 The system is coming up. csm_init CSM_mdm = 0x9a4870 CSM_ops = 0x9a4a0c csm_glob = 0xa5c490 Scanning Mini SBus... Slot #1: BIANCA/DEC FastEthernet Slot #2: BIANCA/PMX Slot #3: BIANCA/MODEM The system is ready. AUTOEXEC: 1 date Mon Oct 31 8:56:12 2022 done 1 configd SystemId: BXP12926006 done 10 isdnd background 11 isdnautocf background 20 x25swd background 20 frd background 21 mpxd background 50 ipd background 51 snmpd background 51 telnetd background 51 syslogd background 51 minipadd background 51 txd background 60 ipxd background 61 ripsapd background 66 httpd background 69 tud background 70 routed background 70 pppd background 70 radiusd background 70 tafd background 80 bridged background 99 bootpd background 99 timed background 99 traced background 99 isdnlogind background 99 vcapid background BOOTP: IP address already set INFO/CONFIG: system brick-xmp started at Mon Oct 31 8:56:23 2022 Welcome to BIANCA/BRICK-XMP version V.4.9 Rev. 3 from 98/12/10 00:00:00 systemname is brick-xmp, location germany Login:
Misc info¶
Modules
> biboAdmBoardTable inx Slot(*ro) Type(ro) HWRelease(ro) FWRelease(ro) PartNo(ro) Connector(rw) 00 0 "BRICK (2/8 MB)" "1.2" "1.2" "BIANCA/BRICK-XMP auto 01 1 "BIANCA/CM-100BT" "1.1" "1.0" "CM-100BT" auto 02 2 "BIANCA/PMX" "2.1" "3.0" "CM-PRI" rj45 03 3 "BIANCA/FM-MODI-5 "1.2" "4.9.3/Rw:2.0.92" "FM-MOD-56K/08" auto
S2M stats
> sysPCMTable inx Slot(*ro) Unit(*ro) ClockStatus(ro) ClockMaster(ro) MasterPrio(rw) Changes(ro) 00 2 -1 not_ready candidate 0 0
Licenses
BIANCA/BRICK-XMP Setup Tool BinTec Communications AG [LICENSE]: Licenses brick-xmp _______________________________________________________________________________ Available Licenses: IP (builtin), OSPF (valid), STAC (valid), CAPI (valid) BRIDGE (valid), IPX (valid) Serialnumber Mask Key State 119102 311 LEBD3RZ ok ADD DELETE EXIT _______________________________________________________________________________
Monitoring und Debugging -> Modem
BIANCA/BRICK-XMP Setup Tool BinTec Communications AG [MONITOR][MODEM]: Modem Calls brick-xmp _______________________________________________________________________________ Index Action Type State Mode Modu- Err Compr TX RX ifindex/ lation Corr Speed Speed BChan 3000 enabled csm56K idle modem unknown none none 0 0 0/0 3001 enabled csm56K idle modem unknown none none 0 0 0/0 3002 enabled csm56K idle modem unknown none none 0 0 0/0 3003 enabled csm56K idle modem unknown none none 0 0 0/0 3004 enabled csm56K idle modem unknown none none 0 0 0/0 3005 enabled csm56K idle modem unknown none none 0 0 0/0 3006 enabled csm56K idle modem unknown none none 0 0 0/0 3007 enabled csm56K idle modem unknown none none 0 0 0/0
SNMP system table
brick:> system sysDescr( rw): "BIANCA/BRICK-XMP" sysObjectID( ro): (bibo) .1.3.6.1.4.1.272.4 sysUpTime( ro): 0 06:14:54.00 sysContact( rw): "BINTEC" sysName( rw): "brick" sysLocation( rw): "Germany" sysServices( ro): 12
Updated by roox 11 months ago · 1 revisions