Project

General

Profile

Actions

Tandberg TTC6-01

This is a rather high-end video codec unit for a teleconference system.

DSC00325.JPG DSC00323.JPG

Hardware

DSC00330.JPG

Mainboard

The mainboard hosts:
  • three microphone input sections
    • XLR input connctor
    • ADI SSM2017 (audio pre-amplifier)
    • ADI AD1849 (16-bit stereo ADC)
  • dual compositve video in/out
    • Philips SAA7113H (50 Ms/s 9-bit video ADC)
    • Philips SAA7112H (video decoder/scaper)
    • HA5024IB video amplifier
  • four-port ISDN BRI line interface
    • Infineon PEB 2086 (ISAC-S)
  • Ethernet port
    • TDK 78Q2120-CG (10/100 Mbps Ethernet PHY)
  • Control / Communications Processor
    • Motorola XPC860TZP50D4 (CPU)
    • 2x Samsung K4S643232E-TC70 (RAM)
    • 2x Intel DA28F640J5-150 (Flash)
    • Cypress CY7C09449PV-AC (dual-port SRAM with PCI bus controller)
  • Video Codec Section
    • 2x unknown codec ASIC or DSP (beneath glued heatsink)
    • each 2x Samsung K4S643232E-TC70 SDRAM
  • Audio Codec Section
    • 4x ADI ADSP-2189M (DSP)

DSC00336.JPG

DSC00342.JPG DSC00341.JPG DSC00339.JPG

Daughterboard

This board hosts
  • 2x ISDN PRI (E1) line interfaces
    • Infineon PEB 2255H
  • 2x ISDN BRI line interfaces (in addition to the 4x BRI on the mainboard)
    • Infineon PEB2086 (ISAC-S)
  • VGA input and output (presumably for screen sharing of a PC)
    • Philips SAA7167 (YUV-to-RGB DAC)
    • ADI AD9884A (140Ms/s RGB ADC)
    • TI 9CAVXDK CBT16214 (multiplexer/demultiplexer)

DSC00332.JPG DSC00333.JPG

Updated by laforge 6 months ago · 2 revisions

Add picture from clipboard (Maximum size: 48.8 MB)