PageOutline = rtl-sdr =
DVB-T sticks based on the Realtek RTL2832U can be used as a cheap SDR, since the chip allows transferring the raw I/Q samples to the host, which is officially used for DAB/DAB+/FM demodulation.Specifications
The RTL2832U outputs 8-bit I/Q-samples, and the highest theoretically possible sample-rate is 3.2 MS/s, however, the highest sample-rate without lost samples that has been tested so far is 2.8 MS/s. The frequency range is highly dependent of the used tuner, sticks that use the Elonics E4000 offer the best range (64 - 1700 MHz).Supported Hardware
So far, the following devices are supported:
- ezcap USB 2.0 DVB-T/DAB/FM stick (Elonics E4000 tuner)
- Terratec NOXON DAB/DAB+ USB-Stick (Fitipower FC0013 tuner)
Other sticks based on the RTL2832U might be added in the future as well.Software
rtl-sdr is a commandline tool that can initialize the RTL2832, tune to a given frequency, and record the I/Q-samples to a file.
The code can be checked out with:
git clone git://git.osmocom.org/rtl-sdr.git
It can also be browsed on http://cgit.osmocom.org/cgit/rtl-sdr/
=== Building the software ===
To build it, simply run 'make' in the src/-directory and make sure you have libusb1.0-0-dev installed.
=== Usage ===
Example: To tune to 392.0 MHz, and set the sample-rate to 1.8 MS/s, use:
./rtl-sdr /tmp/out.bin -s 1800000 -f 392000000
If the device can't be opened, make sure you have the appropriate rights to access the device (udev-rules, or running it as root).
=== Known problems ===
- If the samples are written to a harddrive, and not a ramdisk, samples may get dropped. An improved version with proper buffering and asynchronous usage of libusb is in the works.
To convert the data to a standard cfile, following GNU Radio Block can be used:br
The GNU Radio Companion flowgraph (rtl2832-cfile.grc) is attached to this page. It is based on the FM demodulation flowgraph posted by Alistair Buxton [http://thread.gmane.org/gmane.linux.drivers.video-input-infrastructure/44461/focus=44525 on this thread].