Project

General

Profile

OsmoSDR hardware verification at 28C3

Added by laforge almost 10 years ago

At ‚Äč28c3, the OsmoSDR team was busy verifying the hardware design on the first prototypes.

The result can be summarized as:

  • SAM3U is working, enumerates on USB and can be programmed via SAM-BA
  • E4K tuner driver is working
  • Si570 driver is working
  • FPGA can be flashed via JTAG bit-banging from SAM3U
  • FPGA and SAM3U can speak via SPI

However, there are at least two bugs:

  • USB socket footprint pin-out was mirrored
  • clock output level of Si570 doesn't match FPGA clock input specs (amplitude too low)

The issues have been worked around, and firmware + FPGA development has made progress.


Comments

Add picture from clipboard (Maximum size: 48.8 MB)