Osmo-bts-lna » History » Revision 2
« Previous |
Revision 2/10
(diff)
| Next »
mschramm, 06/20/2018 08:47 PM
adding VNA measurements
misc hardware projects¶
- Table of contents
- misc hardware projects
Osmo-BTS-LNA¶
The Osmo-BTS-LNA is a low noise amplifier intended for DCS uplink reception (MS->BTS). This is DCS1800 for GSM and band 3 for both UMTS and LTE.
The LNA features a 2-stage LNA formed by RF3865 (RFDM/Qorvo) and two EPCOS B3832 SAW.
The board consumes about 200mA @5V. It intregrates a MIC5219-5 LDO and should be supplied with 5.5-12V DC (7V nom.), either- by local connection (DC input), or
- by 'phantom power' via DC biasing from the RF output.
The RF port can be used with U.FL/IPEX or SMA by moving a coupling capacitor. Bias sourcing is available via SMA.
RF measurements¶
The Osmo-BTS-LNA has been tested on an Agilent E8356A. Some performance curves can be seen below. Input signal attnuation was -40, -70, -90 and -110 dBm.
Osmo-BTS-LNA, -40dBm input:
Osmo-BTS-LNA, -70dBm input:
Osmo-BTS-LNA, -90dBm input:
Osmo-BTS-LNA, -110dBm input:
Updated by mschramm almost 6 years ago · 2 revisions