Project

General

Profile

OsmoTRX » History » Revision 7

Revision 6 (ttsou, 02/19/2016 10:47 PM) → Revision 7/83 (ttsou, 02/19/2016 10:47 PM)

= OsmoTRX = 

 OsmoTRX is a software-defined radio transceiver that implements the Layer 1 physical layer of a BTS comprising the following 3GPP specifications: 
  * TS 05.01 "Physical layer on the radio path" 
  * TS 05.02 "Multiplexing and Multiple Access on the Radio Path" 
  * TS 05.04 "Modulation" 
  * TS 05.10 "Radio subsystem synchronization" 

 OsmoTRX is based on the OpenBTS transceiver, but setup to operate independently with the purpose of using with non-OpenBTS software and projects. Currently there are numerous features contained in OsmoTRX that extend the functionality of the OpenBTS transceiver. These features include enhanced support for embedded platforms - notably ARM - and dual channel diversity support for the Fairwaves UmTRX. Most of these features will eventually be merged into mainline OpenBTS, but primary development will occur on OsmoTRX. 

 == Features == 

 =Intel SSE Support= 
 * SSE3 
 * SSE4.1 

 On Intel processors, OsmoTRX makes heavy use of the Streaming SIMD Extensions (SSE) instruction set. Accelerated operations include pulse shape filtering, resampling, sequence correlation, and many other signal processing operations. SSE3 is the minimum requirement for accelerated use. SSE3 is present in the majority of Intel processors since later versions of the Pentium 4 architecture and is also present on low power Atom processors. 

 ARM NEON Support 
 * NEON 
 * NEON-VFPv4 

 Dual Channel (UmTRX only) 

 Two dual channel modes are available: standard dual channel mode and diversity. In standard dual channel mode, each RF 
 path of the dual channel device - currently only UmTRX - supports a different ARFCN. Each path operates independently a 
 nd operates similarly to two separate devices. GSM channel capacity in this mode is doubled. 

 Dual Channel Diversity (UmTRX only) 

 Diversity mode is similar to the standard dual channel mode except each antenna supports both ARFCN channels. In this case, the receiver sample bandwidth is widened to handle both ARFCN's and subsequently converted and demultiplexed into separate sample streams. Each GSM receive path is fed dual signals, where antenna selection diversity is performed by t 
 aking the stronger signal on a burst-by-burst basis. The limitations are that ARFCN spacing is restricted by the receiv 
 e sampling bandwith (currently 400 kHz) and increased CPU utilization. 

 Low Phase Error Modulator 

 == Hardware support == 

 Ettus Research 
 ||USRP1|| 
 ||USRP2|| 
 ||B100|| 
 ||B110|| 
 ||B200|| 
 ||B210|| 
 ||N200|| 
 ||N210|| 
 ||E100|| 
 ||E110|| 

 Fairwaves 
 ||UmTRX|| 

 == Embedded Platform Support == 

 OsmoTRX has been tested on the following embedded platforms. 

 ||Platform||Processor||FPU|| 
 ||BeagleBoard-xM||ARM Cortex-A8||NEON|| 
 ||ArndaleBoard||ARM Cortex-A15||NEON-VFPv4|| 
 ||RaspberryPi||ARMv6k||VFP|| 
 ||Shuttle PC||Intel Atom D2550||SSE3|| 
 ||Ettus E100||ARM Cortex-A8||NEON|| 

 == Status == 

 == GPRS support == 

 == Source code == 

 The source code is available from git.osmocom.org (module osmo-trx). 

 Public read-only access is available via 
  git clone git://git.osmocom.org/osmo-trx 
 You can browse it via cgit: http://cgit.osmocom.org/cgit/osmo-trx/ 

 == Configuration and Build == 

 The only package dependency is the Universal Hardware Driver (UHD). 

 {{{ 
 $ ./configure 
 $ make 
 $ sudo make install 
 }}} 

 == Running == 

 {{{ 
 $ osmo-trx -h 
 linux; GNU C++ version 4.8.1 20130603 (Red Hat 4.8.1-1); Boost_105300; UHD_003.005.004-140-gfb32ed16 

 Options: 
   -h      This text 
   -a      UHD device args 
   -l      Logging level (EMERG, ALERT, CRT, ERR, WARNING, NOTICE, INFO, DEBUG) 
   -i      IP address of GSM core 
   -p      Base port number 
   -d      Enable dual channel diversity receiver 
   -x      Enable external 10 MHz reference 
   -s      Samples-per-symbol (1 or 4) 
   -c      Number of ARFCN channels (default=1) 
 }}} 

 {{{ 
 $ osmo-trx -a "addr=192.168.10.2" 
 linux; GNU C++ version 4.8.1 20130603 (Red Hat 4.8.1-1); Boost_105300; UHD_003.004.000-b14cde5 

 Config Settings 
    Log Level............... INFO 
    Device args............. addr=192.168.10.2 
    TRX Base Port........... 5700 
    TRX Address............. 127.0.0.1 
    Channels................ 1 
    Samples-per-Symbol...... 4 
    External Reference...... Disabled 
    Diversity............... Disabled 

 -- Opening a UmTRX device... 
 -- Current recv frame size: 1472 bytes 
 -- Current send frame size: 1472 bytes 
 -- Setting UmTRX 4 SPS 
 -- Transceiver active with 1 channel(s) 
 }}} 

 == Authors == 

 OsmoTRX is currently developed and maintained by Thomas Tsou. The original code is derived from the OpenBTS project, which was developed by David Burgess and Harvind Samra at Range Networks.
Add picture from clipboard (Maximum size: 48.8 MB)