SciphoneDreamG2 » History » Version 2
steve-m, 02/19/2016 10:49 PM
add serial pinout
1 | 1 | laforge | = Sciphone Dream G2 = |
---|---|---|---|
2 | |||
3 | The Sciphone Dream G2 is a [wiki:MT6235] based phone running UI software to mimic the look+feel of Android. |
||
4 | |||
5 | There is currently an u-boot and Linux port for the MT6235 underway, the primary development platform is the Sciphone G2. |
||
6 | |||
7 | OsmocomBB does not yet support any Mediatek chipsets, so this phone is not supported by OsmocomBB. Nonetheless, we |
||
8 | expect to have support for it at some point in the future. |
||
9 | |||
10 | 2 | steve-m | == Serial Cable == |
11 | |||
12 | You can make a serial cable by sacrificing the headset that comes with the phone, by swapping the pins inside the connector. |
||
13 | |||
14 | Serial pinout: |
||
15 | |||
16 | ||Pin||signal|| |
||
17 | ||1||GND|| |
||
18 | ||2||GND|| |
||
19 | ||5||Rx|| |
||
20 | ||7||Tx|| |
||
21 | |||
22 | [[Image(sciphone_serial.jpg,20%)]] |
||
23 | |||
24 | 1 | laforge | == JTAG == |
25 | |||
26 | The JTAG port of the MT6235 is accessible on the phone PCB, see the attached picture. |