GPS 02 » History » Version 4
laforge, 07/06/2020 12:15 PM
1 | 2 | laforge | h1. GPS 02 01 |
---|---|---|---|
2 | 1 | laforge | |
3 | This is the Ericsson original GPS receiver that can be used to provide a clock reference to equipment like [[DUG 20]] or [[DUL 20]] or also the [[SIU 02]] |
||
4 | 2 | laforge | |
5 | It is also called "NCD 901 41/1" |
||
6 | 3 | laforge | |
7 | h2. Connections |
||
8 | |||
9 | h3. RJ45 for connection to DUL/DUG/DUW/SIU/TCU |
||
10 | |||
11 | The unit has two RJ45 sockets. They appear to have identical functionality. |
||
12 | |||
13 | The pin-out is as follows: |
||
14 | |||
15 | |_.Pin|_.Name|_.Comment| |
||
16 | |1|1PPS-|RS-422 1PPS GPS -> DUx| |
||
17 | |2|1PPS+|RS-422 1PPS GPS -> DUx| |
||
18 | |3|RxD|RS-422 in direction DUx -> GPS| |
||
19 | |4|TxD+|RS-422 NMEA in direction GPS -> DUx| |
||
20 | |5|TxD-|RS-422 NMEA in direction GPS -> DUx| |
||
21 | |6|RxD|RS-422 in direction DUx -> GPS| |
||
22 | |7|12V|supply voltage from DUx -> GPS| |
||
23 | |8|GND|supply voltage from DUx -> GPS| |
||
24 | |||
25 | The supply voltage pins on a [[DUL 20]] only provide 3.1V until the GPS receiver is detected by means of a 1kOums resistor between 12V and GND. At that point, the DUL sources the full 12V. |
||
26 | |||
27 | 4 | laforge | The 1PPS output signal of the GPS 02 only becomes active once there is a GPS fix. |
28 | 3 | laforge | |
29 | h3. SMA for connection to GPS antenna |
||
30 | |||
31 | This includes a 5V DC phantom voltage supply for the active antenna. |
||
32 | 4 | laforge | |
33 | h2. LED |
||
34 | |||
35 | There is a single green LED. |
||
36 | * after power up, it takes some dozens of seconds until it first becomes active |
||
37 | * slow green blinking light indicates powered up but no GPS fix |
||
38 | * steady green light indicates powered up and GPS fix (1PPS output active) |