Colocated Hub » History » Revision 2
Revision 1 (laforge, 04/21/2022 06:09 PM) → Revision 2/27 (laforge, 04/21/2022 06:18 PM)
{{>toc}} h1. Colocated Hub This page exists to collect some planning about the future colocated OCTOI hub, see #5542 h2. Physical Setup h3. Server (specs) High level: * Some 2U machine with capacity to host preferably >=2 full-height PCIe cards (TE820). * SRV-IO to map TE820 into a VM for easier debugging of potential DAHDI kernel crashes * amount of RAM is not very important, the use case has no high RAM requirements * CPU is more critical given all of the the byte-shifting and lots of copying / context switches we have to do for each trunk in the current software architecture * storage is also not very critical, other than for log files / monitoring Candidates: * @laforge has experience with Dell PowerEdge R740 (up to 3 full-height slots) * @gruetzkopf has suggested HP DL830p G8 (up to 6 full-height slots) * @laforge is checking SuperMicro options with riser cards for PCIe h3. DAHDI cards @laforge has at least two TE820 that can be used for this purpose h3. icE1usb We need at leaset one icE1usb as a GPS-disciplined clock master. We can also use that one to compare physical (icE1usb+TE820) setups against DAHDI-trunkdev. We could deploy 1-2 more, just in case. h3. RAS / dial-up server We should install at least one RAS server next to it, for dial-up modem / isdn termination * Definitely the Livingston PM3 currently next to the hub. Needs 1xE1 on the Server * Likely also a Cisco ASR5400 @laforge has acquired h2. Software * Like in the current hub at @laforge's basement, we should run the entire yate / osmo-e1d / dahdi-trunkdev inside a KVM with SRV-IO mapping the PCI devices