This page is a reference fo all VTY commands, both for interactive use at the command line, as well as for the configuration file.

configuration reference

=== network level ===

==== network country code ====

The MCC to be used for this network. Default is 1.

==== mobile network code ====

The MNC to be used for this network. Default is 1.

==== short name ====

This is the short network name to be used in the GSM 04.08 MM INFO message.

==== long name ====

This is the long network name to be used in the GSM 04.08 MM INFO message.

==== auth policy ====

This defines the authentication policy of the network. Possible values are:

• ''closed'': Don't allow anyone who is not marked as authorized=1 in the hlr database
• ''accept-all': Accept everyone into the network
• ''token'': Use a special [wiki:TokenAuthPolicy]

=== bts level ===

==== type ====

The type of the BTS. Currently supported;

• ''bs-11''
• ''nanobts900''
• ''nanobts1800''

==== band ====

The GSM band of the BTS. Currently supported:

*

==== location area code ====

The LAC of the location area to which this BTS belongs.

==== base station id code ====

The BSIC of this BTS within the location area.

==== ms max power ====

maximum transmit power (in dBm) to be used by MS in this BTS

==== periodic location update ====

Specify the number of seconds at which periodic location updating shall be performed by MS in this BTS (T3212)

==== channel allocator ====

Whether the channels should be allocated in ascending or descending order

==== cell barred ====

Whether this BTS is barred from access or not.

==== ip.access unit_id ====

The ip.access Unit ID. Unit ID is used to identify the BTS to the BSC. You set the Unit ID of the BTS by using the [wiki:ipaccess-config] program. Make sure you use the same Unit ID in the nanoBTS as well as in OpenBSC.

==== oml e1 tei ====

The Q.921 TEI to be used for the A-bis OML link of this BTS. Make sure you use the same value than you have set in the BTS.