Revision 3df5a7f2
Added by Kévin Redon over 4 years ago
- added
- modified
- copied
- renamed
- deleted
WARNING: this project only applies to the first generation SIMtrace hardware, which uses the Atmel AT91SAM7S micro-controller. This project is not supported anymore. The hardware and software are still working, but won't get updates. This project is now replaced by SIMtrace2, which uses the SAM3S replacement micro-controller.
schematic: mark R24 as no place
R24 is pulling the voltage regulator output for VCC_SIM down.
it has probably been added at the same time as R15.
since we don't read VCC_SIM it is not important to have it in a
defined state.
also the card, phone, or simtrace will provide power to the card
when required (else the card load is high enough to immediately
pull it down).
this change has been tested with a real simtrace device.
trace and card emulation worked with a Nokia 3310.
Change-Id: Iaae0959b62bc9348279bc5d840addbeb28fdf98f