Actions
SignalScopePage » History » Revision 1
Revision 1/30
| Next »
max, 04/22/2017 04:04 PM
= Signal Scope =
InstallationBefore running the scope app, check that the following packages are also installed: * GNU Radio * The op25 blocks * Frank's gr-fsk4 block * The op25 repeater block
Other than these pre-requisites, no special setup or installation is needed.
Running with the disc-tap optionThe signal scope does not require the USRP. If you have a discriminator-tapped receiver, use the "-a" option:
Updated by max about 7 years ago · 1 revisions
