E1-tap » History » Version 6
laforge, 07/25/2022 09:25 AM
1 | 5 | laforge | {{>toc}} |
---|---|---|---|
2 | |||
3 | 1 | laforge | h1. E1/T1 Tap |
4 | 2 | laforge | |
5 | 4 | laforge | The Osmocom E1/T1 tap adapter allows you to tap into the communication of an E1/T1 line. |
6 | |||
7 | This is useful for tracing/analyzing communications on any type of E1 based interface, such as A-bis, A and core network interfaces in GSM networks, as well as classic ISDN networks. |
||
8 | |||
9 | Two RJ-45 ports are used for passing through your existing E1 line. Using a switch (SW1), the pass-through can be configured in straight or cross-over mode. |
||
10 | |||
11 | Two additional RJ-45 sockets are provided for tapping into either of the two pairs (Rx/Tx) of the E1 line. |
||
12 | |||
13 | An additional switch (SW2) can be used to select between high and low impedance tapping. |
||
14 | |||
15 | All ports are configured in Digium-compatible pin-out, i,e, pairs 1+2 / 4+5 |
||
16 | |||
17 | 3 | laforge | h2. PCB Photograph |
18 | |||
19 | 2 | laforge | !e1-tap.jpg! |
20 | 3 | laforge | |
21 | h2. Schematics |
||
22 | |||
23 | !e1-tap-sch.png! |
||
24 | 5 | laforge | |
25 | h2. Availability |
||
26 | |||
27 | 6 | laforge | The E1/T1 tap adapter is available for purchase from https://shop.sysmocom.de/E1-T1-tap-adapter/e1-tap |