RUS 01 B3 » History » Version 3
laforge, 05/14/2020 09:25 AM
1 | 1 | roh | h1. RUS 01 B3 |
---|---|---|---|
2 | 2 | roh | |
3 | |||
4 | |||
5 | h2. Connectors |
||
6 | |||
7 | h3. PWR |
||
8 | |||
9 | {{thumbnail(RUS_01_B3_DC_in_detail.jpg, size=400)}} |
||
10 | |||
11 | h3. LEDs |
||
12 | |||
13 | {{thumbnail(RUS_01_B3_LED_detail.jpg, size=400)}} |
||
14 | |||
15 | 3 | laforge | h3. Front-Haul interface (CPRI) |
16 | |||
17 | These look like SFP connectors, but are not. They are of a special connector type, but have the same electrical signaling. |
||
18 | |||
19 | We presume Ericsson did this so you cannot easily use a RUS remotely by plugging in a SFP transceiver for fiber optic transmission. |
||
20 | |||
21 | Instead, you have to use special copper CPRI cables from Ericsson: RPM 777 211/xxxxx where xxxxx is the length in mm. |
||
22 | 2 | roh | |
23 | {{thumbnail(RUS_01_B3_Data2_Data1_detail.jpg, size=400)}} |
||
24 | |||
25 | h3. RF |
||
26 | |||
27 | {{thumbnail(RUS_01_B3_RF_A_detail.jpg, size=400)}} |
||
28 | {{thumbnail(RUS_01_B3_RF_B_detail.jpg, size=400)}} |
||
29 | |||
30 | h3. RXA OUT RXB I/O |
||
31 | |||
32 | {{thumbnail(RUS_01_B3_RXA_RXB_detail.jpg, size=400)}} |
||
33 | |||
34 | h3. PA-Filter Jumper |
||
35 | |||
36 | {{thumbnail(RUS_01_B3_PA_Filter_jumper_removed_detail.jpg, size=400)}} |
||
37 | {{thumbnail(RUS_01_B3_PA_Filter_jumper_seperate_detail.jpg, size=400)}} |
||
38 | |||
39 | h3. Connector on the Back |
||
40 | |||
41 | {{thumbnail(RUS_01_B3_backplane_detail.jpg, size=400)}} |
||
42 | |||
43 | h2. Overview Pictures |
||
44 | |||
45 | {{thumbnail(RUS_01_B3_front_perspective.jpg, size=400)}} |
||
46 | {{thumbnail(RUS_01_B3_left_perspective.jpg, size=400)}} |
||
47 | {{thumbnail(RUS_01_B3_right_perspective.jpg, size=400)}} |
||
48 | {{thumbnail(RUS_01_B3_back_perspective.jpg, size=400)}} |
||
49 | {{thumbnail(RUS_01_B3_top_complete.jpg, size=400)}} |
||
50 | {{thumbnail(RUS_01_B3_bottom_complete.jpg, size=400)}} |