Project

General

Profile

Cable antenna » History » Version 7

dexter, 02/19/2016 10:48 PM

1 1 dexter
2
== The Cable Antenna ==
3
4
The antenna that has been shipped with the BS11 is a so called sector-antenna. That means it is designed not to cover only a part of the area around the BTS. And it has a gain. The gain comes from the signal that is bundeled and sent into the sector. The advantage: You can use several BTSs to cover a cell (Each cell sector has its own BTS ==> More calls) and you can cover more distance with less power.
5
6 5 dexter
What is good if you want to run a mobile network is bad for experimental proposes. For us an antenna that covers the area around the BTS with a nondirected signal (like a donut) is perfect - so lets build one.
7 1 dexter
8 6 dexter
Note: I have Adaptors that adapt the BS11 N-Connectors to BNC. Because BNC is my favourite connector type so the most of my homebrew radio equipment / cables have BNC-Connectors. That is the reason why this howto relates to BNC-Connectors. Just use your favorite connector type or N-Connectors for the BS11
9
10 5 dexter
== Step by step ==
11 1 dexter
[[Image(cableAntenna_materials.JPG,width=300px)]]
12
13 6 dexter
The antenna is made out of a pice of old coax-cable (about 15-20cm length) and a BNC connector. To make it all looking good we add a pice of shrink tubing at the end.
14 5 dexter
15 1 dexter
[[Image(cableAntenna_bncplugconnected.JPG,width=300px)]]
16
17 6 dexter
The first task to do is to connect the connector to the cable. I used a solderable BNC-Connector. If you have an old network cable you can cut off the and. The result is the same.
18
19
[[Image(cableAntenna_shieldcutoff.JPG,width=300px)]]
20
21
Now cut of the isolation and remove the metall shield.
22 7 dexter
23
24
[[Image(cableAntenna_cutoff.JPG,width=300px)]]
Add picture from clipboard (Maximum size: 48.8 MB)