ipaccess-config is a small command line tool to configure an ip.access nanoBTS.

You can use this tool to perform basic operations such as setting NVRAM parameters or performing tests

Setting the Unit ID

Assuming that your BTS ip-address is 192.168.100.123:

{{{
./ipaccess-config -u 1800/0/0 192.168.100.123
}}}

Setting the Primary OML address

Assuming that your BTS ip-address is 192.168.100.123 and your BSC ip address is 192.168.100.11:

{{{
./ipaccess-config -o 192.168.100.11 192.168.100.123
}}}

Performing a test

You can perform various BTS tests using the -l option:

{{{
$ ./ipaccess-config -l 66 192.168.100.123
ipaccess-config (C) 2009 by Harald Welte
This is FREE SOFTWARE with ABSOLUTELY NO WARRANTY

Trying to connect to ip.access BTS ...
OML link established
[...]
<0020> abis_nm.c:1886 PEFORM TEST
<0020> abis_nm.c:805 OC=RADIO CARRIER INST=(00,00,ff) Software Activated Report
<0020> abis_nm.c:805 OC=RADIO CARRIER INST=(00,00,ff) Test Report
<0020> ipaccess-config.c:107 TEST REPORT: test_no=0x42 test_res=SUCCESS
<0020> ipaccess-config.c:130 > ARFCN 212, Frequency Error 0
&lt;0020&gt; ipaccess-config.c:130 > ARFCN 220, Frequency Error -23
<0020> ipaccess-config.c:130 > ARFCN 10, Frequency Error -1
&lt;0020&gt; ipaccess-config.c:130 > ARFCN 20, Frequency Error 3
<0020> ipaccess-config.c:130 > ARFCN 29, Frequency Error -10
&lt;0020&gt; ipaccess-config.c:130 > ARFCN 49, Frequency Error -25
<0020> ipaccess-config.c:130 > ARFCN 51, Frequency Error 23
&lt;0020&gt; ipaccess-config.c:130 > ARFCN 53, Frequency Error 1
<0020> ipaccess-config.c:130 > ARFCN 55, Frequency Error -10
&lt;0020&gt; ipaccess-config.c:130 > ARFCN 63, Frequency Error -2
<0020> ipaccess-config.c:130 > ARFCN 80, Frequency Error -2
&lt;0020&gt; ipaccess-config.c:130 > ARFCN 82, Frequency Error 11
<0020> ipaccess-config.c:130 > ARFCN 84, Frequency Error -6
&lt;0020&gt; ipaccess-config.c:130 > ARFCN 101, Frequency Error 0
}}}